Pumps and Related Parts

Flush mount air buttonA great replacement for Martec buttons above. Bellows are accessible fromthe top&ndash no need to remove button!Hole size: 1-1/2"

 

This is a 230V Waterway Tiny Might Circulation Pump that is 1" x 1" which measures about 1 7/8" to the outside of the threads. It is high in efficiency and low on power use. Tiny Might packs a...

This 2HP Impeller fits a Jacuzzi/Carvin Wet End only and would be found on a motor that is about 16.0 Amps on a 115V motor or 10.0 Amps on a 230V motor..... It can be found under the Name Thera-Max...

This part is a Wear Ring for a Hi-Flo Impeller found in Waterway Hi-Flo pumps only.. The Inside Diameter of the wear ring is 1 13/16"...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attac

This Listing is for a Waterway Executive 16.4 Amp 56fr 2 Speed 230V 5 HP 2" X 2" Pump. Your sticker may say 5-6HP. This unit features a 2" X 2" Executive Wet End that can be moved from the 12...

This part is a Start Capacitor, 64-77 MFD, 250v, 1-7/16" Wide x 2-3/4" Tall.. Capacitor Type Motor Start

This part is a Impeller, Jacuzzi, J Pump, 1.0hp, 48FR, J Series, JCM Series, K Series, KM Series.. This is found on a Wet End that has a face like I show in the Pho

Waterway Hi-Flo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 1.5hp, it is used in a Waterway Hi-Flo pump wet end, and must be installed on a...