Heaters and Related Parts

Low flow square back style heater assembly for Dimension One (D-1) hot tubs and spas that utilize the M-Class control system. This 1" heater with dual titanium elements wraps around the control box and has 4 wire connections that connect to your circuit...

Balboa 5.5 KW Titanium heater assembly with stud. Can be run at 230 volts for the full 5.5 KW or at 115 volts for 1.5 KW. This Flo Thru heater has 2" unions that measure 3" on the inside and is 15" in length, measured from flange to flange. Now comes...

This part is a Heater Complete with the Sensor set and built in pressure switch an exact generic replacement for the original Watkins No Fault 6000 76227 heater... This is a generic replacement for the various versions of Watkins/Hot Spring/Tiger...

This part is a Heater Complete with the Sensor set and built in pressure switch an exact generic replacement for the original Watkins No Fault 4000 76228 heater... This is a generic replacement for the various versions of Watkins/Hot Spring/Tiger...

Female quick disconnect for Balboa plug and click heaters. This 6" adapter connects to the heater terminals on your circuit board and then plugs into the male 25263 adapter from your heater on the new Balboa VS, GS and EL circuit boards. Also makes a...

Male quick disconnect for Balboa plug and click heaters. This 16" adapter will connect to your heater element terminals and will either plug directly into the circuit board on BP systems or into the 25696 female adapter on the new Balboa VS, GS and EL...

This part is a Hydro Quip Versi-Heat remote heater replacement assembly. The metal tube measures 2" x 13" with a 5.5 kilowatt, 230v heater element inside. Some versions are 4.5kw but this one will work in place of that version without issue. The black...

This Plumbing & Glue kit is used to change from a Cal Spa Dually Pump setup to a single Pump set up since the dually pump has been discontinued.. You will have to modify the plumbing and note that this kit is for most applications and may not be...

Mounting Kit used to attach the Universal Rite-Fit Low 3" Flow Vertical Heaters to your spa pack or control box to match the OEM configuration. Includes bracket, clamp and hardware.

This part is a Heater for a Bath or Garden Tub.. H-Q InLine, 115v, 1.0kW, 3ft, Replaces Versi-Heat with Pure Heat... This heater can be used with 1 1/2" pipe which would measure about 1 7/8" OD.. You could use it wil 1" pipe with a reducer bushing....

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434 Type Standard Spa Brands Sundance/Jacuzzi

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...