Heaters and Related Parts

Balboa Water GroupStainless steel replacement heater assembly, 5.5kW/230v, 2" x 15". Includes a pressure switch, Hi Limit Sensor on the right side. Made for Balboa Value and Balboa LE control systems...

This part is a 2" Center to Center O-Ring that fits some 1 1/2" Pump Unions that features a 2" groov

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade..

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade..

This is a 1-1/4"npt Plug Element that is 9 3/4" long and it threads into a fitting in the plumbing.. With 10-32 thd studs, dual 5/16" thermowells, predrilled holes for mounting junction box 1-1/4"...

This part is a Replacement "A" Coupling Gasket "Only" for all some Saluspa or Lay-Z-Spa AirJet™ Hot Tub models (Siena, Miami, Havana, Paris, Palm Springs Air Jet, New York, Vegas, Saint Tropez,...

NOTE: THIS PART FITS A BLOW UP INFLATABLE HOT TUB ONLY DO NOT ORDER IT FOR A TRADITIONAL HOT TUB!!  This part is a Replacement "A" Coupling for Water jet spa for all some Saluspa or Lay-Z-Spa AirJ

This part is a Hydro Quip Silver B Series Flo Thru Heater this 2-1/4" x 15", 5.5kw, used in the Remote Slide Versi Heat Type heater.. This heater does no

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater  

This Parts is a NON-Standard 2" Heater or Pump Union O-R

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch...

This part is a 15" Heater Tube with a 4.0KW Heater in it that is found in some Jacuzzi Premium J-200 Series tubs and some Sundance 680 & Del Sol tubs as well with a High Flow .. For other parts...