Generic

Brass Fitting that fits an 1/8" MPT heater fitting on one side a 1/8" ID tube on the other side. I have seen these in AP-1400 Len Gordon Pack to attach the heater to the pressure though there are...

This part is a Standard 5.5KW Incoloy Heater Element for 230V or 115V Applications that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits...

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and...

This tool is a Flex Pipe or Vinyl Tubing Cutter works on air line 3/8" up to water lines 1".. 3/8" air, 1/2" Water, 3/4" Water Vinyl or Flex and 1" Water Vinyl or Flex..  Tool Type...

This O-Ring can be found in some American Products, AquaFlo, Gecko, Hayward, Sta-Rite, Pentair, Sonnafarrel, Martec, Advantage, Filter housings to seal the multiport. Application - Category Filter,...

This o-ring is used in many different applications such as heater 2" tailpiece unions or pump unions as well as some pool applications. The inside diamter is 2 3/8 and it is 1/8" wide. Applications:...

Part Type    O-RingJet Part Type    Gasket/O-RingCross Section    1/16"Manufacturer    HydroAir/BalboaModel    Micro...