Dimension One Hot Tub Parts

This part is a Coleman, Maax & California Cooperage Lounge Pillow 6-1/2" Tabs, Gray, 103-416 Hot Tub Pillow that is 9 1/2" x 4 1/4"  and 6-1/2" between the Tabs.  It is 4 1/4" Wide at the top and 9 1/2" Long it...

This part is a D-Tec 2 (1) Amp 2PSI Pressure Switch that features 1/8th" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections and is Ideal for applications where a larger switch will not fit. This Switch is a...

This Kit is a Set of (4) Total Combination of the Two Standard Size 2" Heater or Pump Union Gasket (2) with a 2 1/2" Lip Center to Center and (2) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know...

This Kit is a Combination of the Two Standard Size 2" Heater or Pump Union Gasket (1) with a 2 1/2" Lip Center to Center and (1) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know which size you have...

This part is an Air Check Valve Kit with a 1" Air Check Valve a (4) 3/8" Barb Transistion Manifold with (2) Plugs that can be down to (2) Barbs and a 4oz can of glue to glue it all together. This valve is used above the water line to allow constant...

This part is an Air Check Valve with a 1" Slip Fittings on one end. This valve is used above the water line to allow constant air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. This type Check...

This Kit is a 2" Pump Union, Slice Valve, Spin Kit To Plumbing Connect Kit with Glue found in many Hot Tubs. The Pump Union which measures about 3" Inside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it to...

This Kit is a 2" Pump Union, Slice Valve, Spin Kit To Plumbing Connect Kit found in many Hot Tubs. The Pump Union which measures about 3" Inside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it to win it on...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Hot Tub Pillow that is 9 1/2" x 4 1/4"  and 6-1/2" between the Tabs it fits a variety of brands some are out of business. It fits some Infinity, Raindance, Serenity, Premier, Serenity, Dimension One and Also Four Winds...

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...