Bath Garden Tub Pumps & Related Parts

This part is a Union Tee, Balboa Vico Ultima/UltraFlo, 1-1/2"fbt x 1"slip x 1"slip.. This part is usually found in a garden bathtub setup not a hot tub in your backyard..  The threaded Pump Union part measures 2 3/8" across the threads and the...

This pump is a Wow High Performance Pump with 1 1/2" x 1 1/2" connections that measure about 2 3/8" across the threads.. It is a 3/4HP 115V 7.5Amp .75HP pump with an Air Switch and Cord.. This Vico-Ultrajet range of Hydro-Massage Whirlpool Pumps have...

This part is a Heater for a Bath or Garden Tub.. H-Q InLine, 115v, 1.5kW, 3ft, Replaces Versi-Heat with Pure Heat...   Bath Heater Type Pressure Plumbing Style In-Line Voltage 115v Wattage 1.5kW First Plumbing...

This part is a Bath Style (1) Speed Jacuzzi J-Pump, 115v, J Pump Style Fitting, 7.5A, w/Air Switch...   Note: This pump is equipped with an air switch. If the motor does not start upon plugging it in, the switch may be in the off position...

This pump has been discontinued.. This pump is an Aqua-Flo Tub-Master Energy Efficient Bath Pump 10.0 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads....

This part is a Balboa 115V Control System used in Garden Style Bath Tubs.. You plug the controller into a wall plug, then plug the 115V Bath pump into the controller then mount the button and plug the wire in from the mounted button and the button will...

This part is a Water Control Sensor Kit or an ACC BC100 Control System used in Garden Style Bath Tubs.. For the control system related to this sensor click here: Bath Control, Electronic, ACC BC100, On/Off w/Button, 15A, 115V, 20 Min Delay

This part is a 115V Control System used in Garden Style Bath Tubs.. You plug the controller into a wall plug, then plug the 115V Bath pump into the controller then mount the button and plug the wire in from the mounted button and the button will control...

This Part is a Bath Pump Seal for a LX, DH1.0 Series Guangdong Bath Garden Tub Pump Only. It is 1 3/16" Across the back of the Spring Seal part that goes onto the back of the impeller with a hole size of about 5/8"..  The Ceramic & Rubber part...

This part is (1) 1/8"x 1/8" X 1/8" Barbed Tee In-line Air Bleed that fits 1/8" OD , 3/16" ID Clear Hose on each side. These Will prevent very sensitive air switches from randomly activating due to thermal expansion of air and water vapor..  

This Part is an 48 Frame 2.0HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 16 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This Part is an 48 Frame 1.5HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 14 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...