Heaters and Related Parts

This part is a 2" Center to Center O-Ring that fits some 1 1/2" Pump Unions that features a 2" groove. The O-Ring is 2" center to center and fits Magic Plastics 2" pump unions but there are exceptions which normally would be a 2 1/8" center to...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This is a 1-1/4"npt Plug Element that is 8" long and it threads into a fitting in the plumbing.. With 10-32 thd studs, dual 5/16" thermowells, predrilled holes for mounting junction box 1-1/4" threaded elements measure 1-1/2" outside diameter.....

This is a 1-1/4"npt Plug Element that is 9 3/4" long and it threads into a fitting in the plumbing.. With 10-32 thd studs, dual 5/16" thermowells, predrilled holes for mounting junction box 1-1/4" threaded elements measure 1-1/2" outside diameter.....

This part is a Replacement "A" Coupling Gasket "Only" for all some Saluspa or Lay-Z-Spa AirJet™ Hot Tub models (Siena, Miami, Havana, Paris, Palm Springs Air Jet, New York, Vegas, Saint Tropez, Hawaii and Monaco). If the "A" Coupling for...

This part is a Replacement "A" Coupling for Water jet spa for all some Saluspa or Lay-Z-Spa AirJet™ Hot Tub models (Siena, Miami, Havana, Paris, Palm Springs Air Jet, New York, Vegas, Saint Tropez, Hawaii and Monaco). If the "A" Coupling...

This part is a Hydro Quip Silver B Series Flo Thru Heater this 2-1/4" x 15", 5.5kw, used in the Remote Slide Versi Heat Type heater.. This heater does not come with the box and other related parts you would transfer them form your original heater..

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa B2DG and B240 Systems.   Circuit Board Application    Balboa Water GroupCircuit Board Model    B2DG, B240Circuit Board...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

This part is a 15" Heater Tube with a 4.0KW Heater in it that is found in some Jacuzzi Premium J-200 Series tubs and some Sundance 680 & Del Sol tubs as well with a High Flow .. For other parts related to this heater Click the links: Pressure Switch...