Pumps and Related Parts

This part is a Starter Capacitor that fits many 115V Pump Motors. Start Capacitor, 161-193 MFD, 115v, 1-7/16" x 2-3/4" When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... There are (2) Different versions of the...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This is a Flat Gasket for 2" Pump or Heater Union Extra Thick 1/4". It is a 2 7/8" Outside Diameter and 2 1/8" Inside Diameter.

Grundfos Circulating Pump 115V with 1" Barbs... In my opinion this is a better pump than the Laing Brand... Spa Guy Note: If you are using this pump to convert from a Laing you will need this Conversion Kit If you want the same kit but need Glue Click...

This Seal Kit PS-3868 Seal is an Upgraded Better Viton Carbon Graphite Version of the PS-201 Seal used Primarily in Vico & Sta-Rite Wetends.It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber...

This part is a Salt/Ozone Resistant PS-3865 which is the upgraded Better version Viton Carbon Graphite version of the PS-1000 Seal. This Seal is used Primarily in Waterway Brand Wet Ends. NOTE: This Seal does not fit a Waterway Viper or EX2 Wet End.. It...

This Seal is a PS-3867 which is the Better - Viton Carbon Graphite version of the PS-200 Seal used Primarily in Aqua-Flo Wet Ends and Waterway "Viper" Wet Ends. It is 1 1/4" Across the back of the Spring Seal part that goes onto the Impeller and the...

This part is a 1 1/2" Pump Union Split Nut Repair Kit which includes the split nut and (2) Screws for use with a 1 1/2" Pump Union. The Pump Union Split Nut that measures about 2 7/8" on the outside and mounts to the existing Pump Union Body using 2...

This part is a Gasket Heater Union Mo-Flo, 2" ID x 2-3/4" OD Cal Spa with a 2-5/8" Center to Center Small Lip.. The Lip is about 2-5/8" Center to Center but is really thin and tiny meaning the other style gasket with a thick 2-5/8" lip will not work....

This part is a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. See Pictures for measurements. The Union receives a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wet...

This O-Ring is 5 1/8" Inside Diameter and 3/16" wide and is used in many applications for Wet Ends between the Face and Volute or under a Trap Lid brands include Hayward, PacFab, Pentair, Sta-Rite in these series Dura-Jet DJ Series Wet End Faces, Dynamo,...