Pumps and Related Parts

This part is a 2 1/2" Pump Union Gasket Only for use with a 2 1/2" Pump Union that would measure about 3 5/8" Inside Threads. This gasket measures 3 1/4" O.D. x 2 3/8" I.D. and the lip is 2 7/8" center to center. This version is the 4th most...

This part is (1) Bearing that fit most motors that are used in hot tubs, this bearing is 17MM ID.. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric NOTE: Installing bearings requires...

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This part is a Standard 1 1/2" Heater or Pump Union Gasket. The gasket is 2 3/8" across and fits unions that have a 1...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...

This part is a O-Ring Heater or Pump Union 2-3/8" ID 1/8" 2 1/2" Center to Center This o-ring is used in many different applications such as heater 2" tailpiece unions or pump unions as well as some pool applications. The inside diameter is 2 3/8 and it...

This Seal is a PS-201 Seal used Primarily in Vico & Sta-Rite Wet Ends..  It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber part that goes into the Volute or Wet End Back is 1 3/8"...

You are buying a PS-1000 Seal only. This Seal is used Primarily in Waterway Brand Wet Ends. It is 1 3/8" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes into the...

This part is a 2" Pump Union Split Nut Repair Kit which includes the split nut and (2) Screws for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the Threaded Side and mounts to the existing Pump Union Body...

You are buying a Kit that Features (1) PS-200 Seal for Aqua-Flo Pumps. This Seal is Used Primarily in Aqua-Flo Wetends but is found in some other brands like a Waterway "Viper*" Wet End. Pump Seal Assy 5/8"Shaft, 1.218"Seal O.D., 1.250"Seal O.D. The...

Flat Gasket for 1-1/2" Union Pump or Heater, 2-5/16" OD, 1-7/16" , This gasket can be used in conjunction with an o-ring when you need extra room for a tighter seal.

This part is a Flat Gasket for 2" Union, 2-15/16" OD, 2-1/8" ID no Lip, This gasket is used in many applications and can be using in combination with an o-ring if you need extra thickness to make a good seal. Heater Union Part Type  ...

This part is a Standard 2" Heater or Pump Union Gasket with a 2 1/2" Lip Center to Center. The gasket is 2 7/8" across on the outside the inside diameter is about 2 3/16" and the lip that fits into the union is 2 1/2" center to...