Pumps and Related Parts

Vico/Balboa Ultima/Ultra Flo Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 3/4hp, it is used in an Ultima and/or Ultra Flo pump wet end, and must be installed on a 3/4hp (or greater) thru bolt...

This pump complete is not longer available but we have a solution.. If you need the motor click here and then click on the pump parts section.. Order the motor and then order the pump parts needed to complete the repair while reusing your pump housing....

This Pump is a 48Frame 115V 2 Speed with a 1.5-2.0 HP Wet End that features a 1 1/2" x 1 1/2" Center Discharge inlet and outlet Wet End that measures about 2 5/16" across the threads...  High speed Amperage is 13.3A and low speed is 4.1 Amps....

This part is a Complete Flo-Master FMCP 1HP Aqua-Flo 1-1/2" x 1-1/2" ( Which measures about 2 3/8" Across the Threads) Center discharge 48 frame wet end for 48FR pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High...

This Listing is for a (1) Speed Waterway Executive 56fr 230V 3 HP 2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps. Measure the intake and pressure side threads and match them up before ordering.  This...

This part is no longer available you must buy a complete wet end to get this part. This part is a Faceplate found on FMHP and FMCP side discharge wet end faces.. Below will be links to the other related parts to this face: Shaft Seal Kit, PS-200, 5/8"...

This Pump is a 48Frame 115V 2 Speed with a 1.0 HP Wet End that features a Side Discharge 1 1/2" x 1 1/2" inlet and outlet Wet End that measures about 2 5/16" across the threads...  High speed Amperage is 9.5 and low speed is 3.2 Amps....

Start Capacitor1-7/16"dia x 2-3/4"hgt

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 9.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This part is obsolete you must choose a complete wet end..  Click this link for Xp2 Wet Ends.. XP2 and XP2e Aqua-Flo Complete Wet Ends This part is the Volute or the back part of a 48 Frame Aqua-Flo XP2 or XP2e Wet End.. We offer the entire wet...

This 230V Laing E-10 pump with a 1" Barb Suction and Pressure Side which measures about 1" Outside Diameter and the hose is 1" Inside Diamater  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly efficient and designed with...

Half Union Fitting Complete Set... The Threaded side measures about 2 3/8" Inside and the Slip Glue end measures about 1 7/8" Inside Diameter... Note: Although this measures very much like a 1 1/2" x 1 1/2" Slip pump union it only fits Hayward Pumps...