Topside Controls (Control Buttons)

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out...

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Jets, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa B2DG and B240 Systems.   Circuit Board Application    Balboa Water GroupCircuit Board Model    B2DG, B240Circuit Board...

This board is a replacement board for Circuit Board, Jumpking (Balboa), ICONM7, 2000LEM7, 230V (3 Wire, No Neutral), 8 Pin Phone Cable. This board replaces product identified with chip number ICONM7R1A. This board is a 3 wire connection (no neutral)...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Jet, Jet, Temp and Light left to right. Make sure your old topside does not have a raise area for...

This part is a Control Box Cover that fits Balboa VS or GS Series Control boxes only..

Gecko In.Yj retro-fit control system w/ 4.0 KW remote heater. This unit is an economical retro-fit kit that has a small footprint and fits in tigh spots. The heater can be mounted within 4 feet of the spa pack. You can wire your components to the circuit...

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is no longer available, but we do have a replacement here: Hydroquip / Gecko ECO-1 Crescent Shaped 4 Button Topside Control Panel   This part is a Eco Series Hydro-Quip, Eco 5, 4 Button, (1) Pump, Light, Aux, Small Rectangle, 10ft...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Blower, Jet, Temp and Light left to right. This Overlay can be used to replace your original...