Hot Tub Parts by Tub Brand

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts,...

This part is a flow-thru style is used on the 2006-forward Solana TX (triangle spa), RX (round) & SX (square) as well as the 2006-forward Hot Spot models except the Sprint and Dash. 15” length 4.0kWgrounding and mounting studsTemp Sensor or...

Heater, FloThru, Watkins TR, 15" x 2", 4.0kW, 230v, Generic Note: This heater does not have a Pressure Switch port or studs for the ground bar..   Housing Configuration    StraightHeater Length    15"Lead End...

This 2.0 Horse Power 230V 10.0/3.0 Amp (2) Speed 48 Frame Complete Pump is a Lingxiao LX Brand Pump. These pumps usually have the part number 48WUA2002C-II on the label for a Watkins Version. Watch the video for instruction on how to...

This part is a Filter Basket found in some older Cal Spas.. Basket Type Skimmer Application Manufacturer Waterway Application Model Top Mount Skimmer Basket Height 5-5/8" Bottom Outside Dimension 5" Top Inside...

Note: This heater IS NOT Exactly like the original as the original is not longer avaliable.. This will work in place of the old one but it is not going to jump in it will require effort and mechanical ability.. If you are not willing to apply effort in...

Brass Fitting that fits an 1/8" MPT Jacuzzi heater fitting on one side a 3/8" ID tube on the other side. I have seen these in Jacuzzi Premium Trombone Heaters to attach the heater to the bleeder system though there are many applications this can be used...

This part is a Replacement Elite Vane Style Filter Weir in Gray. It measures 7 3/4" edge to edge across the bottom of the vane and it about 5" tall without the cap. It has a phillips screws that hold it into place and (2) locking long pins that lock...

This part is a Cal Spa Replacement Version of the Genesis 7000 or 9800 System Retrofit Topside that is replacing the original topside that was scrapped because it had so many issues. Cal Spa replacement for Cal Spa dash board style topside control...

Note: When you order this pump you will receive the newest version of the pump which is a baseless and you will receive the base as well.. This will be able to be installed in any position but you will have to install the base which may not line up with...

This Kit fits a 1019801-03 or 39577-03 Vendor Code 3536 LX 2 HP Pump and Includes an Impeller, Seal, Bearing, Silicon and Seal Installation Tool... It is about 4 1/8"" across the face edge to edge, it measures about 3" from the tip of the front to the...

This part is a Pump Bleeder Barb fits some Watkins Wavemaster XP2, XP2E, LX and others.. It is 1/4" Barb x 1/4"Mpt and is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part...