Digital Electronic Topside Controls

3 button Mini Oval topside control panel made by Balboa. This topside is also known as the VL200 and been used industry wide. This 3 button panel has a button for jets, light and temp up/Down. It measures 4-3/8" x 1-5/8" and requires a hole size of...

This kit is no longer available you would choose this kit: Retrofit MODPACK 202 Control Pack, (2) Pump, Blower, Circ Pump, Ozone and 5.5kW, 230v This is a Balboa Retrofit Complete control system with a 15" long heater tube that will run (3) Jet...

You are purchasing a Balboa Board Fuse Repair Jumper for board soldered on fuses found on many Balboa Brand Spa Hot Tub Boards. This jumper features a fuse holder with a .5A replaceable Fuse that can be added to any soldered on board fuse that has been...

Balboa and HydroQuip have discontinued this Lite Leader based system. See below for two retro-fit options Retrofit Base Control, Balboa BPBEE, (1) or (2) Pump with 4.0kW Remote Heater, TP200T Retrofit MODPACK Control Pack, (2) Pump, Ozone and 4.0kW, 115v...

No cords are included with this replacement pack. Dimensions of control system: Heater: 2Ó x 15Ó Box Height 11-1/2Ó Box length 14-1/4Ó Box Width 3-3/8Ó The S-class series of spa controls presents versatility and...

T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repair ActionCoilAmps SPST 24 VDC 30amp Coil Voltage Type DC Relay/Contactor...

Ths is a Direct Replacement controller for a Gecko SSPA System this pack will run (1) 2 Speed pump, an Ozonator and a light only. Please be sure that you make sure your topside is compatible. It is only compatible with TSC-9, TSC-18 or TSC-19...

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...

This Part is a Back Light Bulb for a Balboa Topsides only. Backlight Bulb Used In Balboa Water Group Digital Topside Controls Series 701 and 724 You will need a Small Flat Screwdriver to remove and install this bulb. Note: Not all Balboa Topsides have a...

This part is for a Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the circuit to...