Digital Electronic Topside Controls

T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repair ActionCoilAmps SPST 24 VDC 30amp Coil Voltage Type DC Relay/Contactor...

Ths is a Direct Replacement controller for a Gecko SSPA System this pack will run (1) 2 Speed pump, an Ozonator and a light only. Please be sure that you make sure your topside is compatible. It is only compatible with TSC-9, TSC-18 or TSC-19...

This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures 2" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    EL,...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...

This Part is a Back Light Bulb for a Balboa Topsides only. Backlight Bulb Used In Balboa Water Group Digital Topside Controls Series 701 and 724 You will need a Small Flat Screwdriver to remove and install this bulb. Note: Not all Balboa Topsides have a...

This part is for a Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the circuit to...