Parts by Group

This part is a Balboa Heater Tube M7 Sensor Mount only. This Mount is screwed into the heater tube and the M7 sensor is slid down in the mount and screwed onto the mount. It DOES NOT include the tube or the sensor they are included in the pictures to...

This part is a Complete Jet Internal, Pentair, Cyclone Jet, 5" face diameter, 7 Hole Roto, Textured, Gray.. This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part...

Internal, Pentair,  Cyclone Jet, 5" face diameter, Swirl, 5 Scallop, Dark Gray This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part Type Internal Diffuser...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face with a 2 1/2"...

This Listing is for a Waterway Executive 16.4 Amp 56fr 2 Speed 230V 5 HP 2" X 2" Pump. Your sticker may say 5-6HP. This unit features a 2" X 2" Executive Wet End that can be moved from the 12 O'clock position to the 3, 6, or 9 O'clock position and a...

This part is a Complete Jet Internal, Pentair Cyclone Jet, 5" face diameter, Swirl, 5 Scallop, Black... This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part...

This jet is obsolete but there is a replacement here: Gray 5" Scalloped Jet This Parts is a Complete Jet Internal, Pentair, Cyclone Jet, 5" face diameter, Directional, Textured, Gray.. This will replace Sundance Intelli-Jet LX,...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...

This Listing is for a Waterway Executive 56fr 2 Speed 230V 3 HP 2 1/2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps. This unit features a 2 1/2" X 2" Executive Wet End that can be moved from the 12 O'clock...

This part is a 4 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak at the wet end.. Note: It has to be placed on the motor...

This Pump is a Waterway Executive, 3.0hp, 230v, 2-spd, 48fr, 2" x 2", OEM The 2" Fittings measure about 3" edge to edge across the threads..  Spa Pump Features: Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter...