Parts by Group

This Listing is for a Waterway Executive 56fr 2 Speed 230V 2 HP 2" X 2" Pump. Your sticker may say 3HP but based on the chart it is really a 2HP at 10 Amps. This unit features a 2" X 2" Executive Wet End that can be moved from the 12 O'clock position...

This Kit is an 5HP Impeller for an Executive 48 Frame Wet End up to 5HP Motor and a 56 Frame Wet End 5HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a Complete Jet Internal, Pentair, Cyclone Jet, 5" face diameter, Swirl, Textured, Gray.. This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part...

This Kit is an 3HP Impeller for an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 3HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This Listing is for a Waterway Executive 56fr 2 Speed 230V 4 HP 2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps, but Waterway considers this a 4 HP. This unit features a 2" X 2" Executive Wet End that can be...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...