Topside Controls (Control Buttons)

You are purchasing a New Balboa 52295 Non M7 Spa Hot Tub Board. Watch the video for more information including some diagnostic tips.. This board does use a pressure switch.   Board is used with an E7 Topside and can run up to two pumps and...

This part is a Balboa, E7, (7) Button, Topside, Standard Digital, (2) Pump & Blower, Light...This panel replaces all Serial Standard Digital products. It also utilizes the Cat 5 phone type connector. Other Overlays: Overlay Balboa Topside 7 Button...

This part is a Relay, Closed Style, T-90 Type, 12vdc, Coil, 30 AmpCircuit board mounted. Use to complete simple circuit board repair. Action Coil Amps SPST 12 VDC 30amp Coil Voltage Type DC Relay/Contactor Style Relay Pole/Throw Single Pole...

This part is an Overlay, Hydro-Quip Eco 1, Pump 1, Light, Temp Up, Temp Down, Small Oval This small oval label fits the Eco-1 4-button panel  Manufacturer HydroQuip Model Eco-1 # of Buttons 4 Part Type Overlay

The following circuit board(s) are compatible with the above topside: 59-138-1037, 59-138-1046, 59-138-1680, 59-138-1683Overlay part number 58-138-1255

Duplex Digital and Super Digital/M-1 Replacement Boards This board requires a 120v power supply and can work with any DuplexDigital. It is found on the Balboa M-1 system. Balboa circuit boards are marked with a ÒChip NumberÓ that is located...

This relay is No Longer Available.. T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repair Action Coil Amps SPST 18 VDC 30amp

Vita Spa Circuit BoardThe following topside(s) are compatible with the above circuit board: 58-103-100402-18-11 There is now a revision to this board. A resettable fuse has been added to protect the board from being damaged when hooked up to a defective...

Analog Duplex PanelThis panel replace duplex product and utilize a "phone plug" type connector, 8 cord length. Topside Type    ElectronicTopside Complete    Complete TopsideManufacturer    Balboa Water...

This circuit board has been discontinued. You will need to install a new retro-fit control system, see below for choices but be sure to verify these have the correct support for your model:Control Retrofit Kit Balboa BP7, 1 or 2 Pump/Blower ,Ozone...

Note: This board is Obsolete but you can use this board: Replacement for this Board.. This Balboa Board is a VS-500 meaning it is a one jet pump board that will run a 12V light and a Circulation Pump also if equipped... This board can be found under all...

Dimensions 3-1/4Óx7Ó This TSC-8/K-8 control panel will work with most MSPA systems, has 8 buttons including a filtration cycle button, and will control dual pumps and an air blower. It has an LCD display and comes with a 10ft cord. This topside also...