Pump Wet Ends and Related Parts

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have only (1) left.. This is the Reverse Side Closed face impeller made for the Power-Right PR420-5R Dually spa pumps. Seals & kits for this Impeller can be found here: 201...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have very few left.. Closed face impeller made for the Power-Right PR420-5F spa pumps. Seals & kits for this Impeller can be found here: 201 Seals Impeller Type    Closed...

This part is an Impeller for a 48fr Vico Ultima or Ultra Flo, 0.50hp, Jet or Circulation Pump... Closed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 1/2hp, it is used in an Ultima and/or Ultra Flo pump wet end, and...

This part is a 2.0HP Impeller fits some Jacuzzi, Sundance or Watkins Thermax Wet Ends only and would be found on a motor that is about 8.0 to 10.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo and is found on Jacuzzi...

This part is discontinued by the manufacturer.. This Part is a Power-Right Pump Face Plate only.. Related Parts: Impeller, Power-Right, 9089X/504, 2.5ohp/5spl Face Plate, Power-Right, Cal Spa, Power Right, Pump, Wet End, Volute, 5 Bolt, 2" X 2"...

This Part is a 1HP Impeller that fits an E-Series 48 Frame 1 1/2" Center discharge Wet End which is found in hot tubs some but on Above Ground pool pumps many times. This Impeller fits between the Face and the Volute of an E-Series Wet End. I...

This 5 3/4" Inside Diameter O-Ring fits around the face of a Waterway HI-Flo 48 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! As you can see below it fits other pumps and filter housings as well.. Part...

This O-Ring fits most pump Drain Plugs..  

This part is a 5 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and Wear Ring.  The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

You are buying a 4 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous...

You are buying a 3 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.              The Bleeder Barb Replaces one of the...

You are buying a 1 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous...