Wet End Pump Parts

This part is NO Longer Available and there are no replacements.. This Part is a Volute Back with 4 mounts only for a Piranha Ther-Flo, Thera-Max  pump only. This Part is used mostly in Jacuzzi® and Sundance® hot tubs with this specific...

This Part is a Set of * Face Plate Screws for Piranha, Thera-Flo or Thera-Max pump faces only. This Part is used mostly in Jacuzzi® and Sundance® hot tubs with this specific type of wet end and will not fit others. For other parts related to this...

This Part is a Volute Back with 8 mounts only for a Piranha Bracketless pump only. This Part is used mostly in Jacuzzi® and Sundance® hot tubs with this specific type of wet end and will not fit others. Note: There are two different versions of...

This part is a Power Right Wet End Pump Face O-Ring Only fits around the Face of a Power Right Pump Face Generally found on Cal Spaa which has 2" inlet and outlet which measures about 3" across the threads...   Related Parts: Impeller,...

This part is an Jacuzzi J Pump Face O-Ring.. It measures about 5 1/2" ID and has a 3/16" cross section Part Type O-Ring  O Reference Number O-150 Inside Diameter 5-1/2"id Cross Section 3/16" Application...

This part is a Wear Ring that only fits Guangdong LX or LP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 3/4" thick from front to back... WUA Pumps.. Note: When Replacing some original LX Pump faces the wear ring was built into the face....

You are buying an Air Bleeder Mountable Bleeder Fitting with a removable plug, a 1/4" Mpt X 3/8" Barb plug. This style set up is is usually found in Dimension One Hot Tubs in the Filter area and other brands as well.. Note; The plug is not sold...

This is a 4HP Seal, (2) Bearing and Impeller Kit.. The Impeller has a 2 1/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor would be about 14.0 Amps on high speed at 230V. Note: The three things you need to know to get the correct Aqua-Flo...

This is a 4HP Seal, (1) Bearing and Impeller Kit.. The Impeller has a 2 1/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor would be about 14.0 Amps on high speed at 230V. Note: The three things you need to know to get the correct Aqua-Flo...

This O-Ring fits most pump Drain Plugs..  

This part is an Add On Air Bleeder kit featuring a Mountable Bleeder Fitting with a removable plug, a 1/4" Mpt X 3/8" Barb plug, (2) Clamps for each end of the tubing and 36" of Clear 3/8" ID and Silicon sealer..   This kit can be added if you...

This is a 2.0HP Seal, (2) Bearing and Impeller Kit.. The Impeller has a 2 1/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 2.0HP Motor would be about 11.0 Amps on high speed at 230V or 16.0 Amps on High at 115V. Note: The three things you need to...