Cal Spa Hot Tub Parts

This part is a Hour Glass Pillow Black, Four Winds, Genesys, Cal Spa, Coast Spa  It fits some Cal Spas, Master Spa, Coast, Genesys and Also Four Winds It is 4" Wide in the center and 4 5/8" on the ends and 8" Long at the widest point....

This Part is a Cal Spa Jet, 5" Power Swim Jet, TW, Tornado, Volcano.. NOTE: Cal Spa Has discontinued the Jet with the CAL Spa name on it but they have a Standard Garu Jet to replace it that you will see in the 2nd Picture..  The diffuser found...

This Kit is a Set of (4) Total Combination of the Two Standard Size 2" Heater or Pump Union Gasket (2) with a 2 1/2" Lip Center to Center and (2) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know...

This Kit is a Combination of the Two Standard Size 2" Heater or Pump Union Gasket (1) with a 2 1/2" Lip Center to Center and (1) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know which size you have...

This Kit is an Upgraded 3 3/4" Wide Buttress Silver Diverter Valve Cap, Valve Stem with a Swoosh Black Knob and O-Ring Kit. This Kit comes with The Swoosh Handle, Valve Stem, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring...

This Kit is an Upgraded  3 3/4" Wide Buttress Diverter Valve Cap with a Black Knob and O-Ring Kit. This Kit comes with The Teardrop Handle, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" slip or 1" Street, Gray, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one...

This part is an Air Check Valve Kit with a 1" Air Check Valve a (4) 3/8" Barb Transistion Manifold with (2) Plugs that can be down to (2) Barbs and a 4oz can of glue to glue it all together. This valve is used above the water line to allow constant...

This part is an Air Check Valve with a 1" Slip Fittings on one end. This valve is used above the water line to allow constant air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. This type Check...

This is a Heater for a Balboa flo-thru found on Lite Leader Packs.. 54115, 54114. It features a Stainless steel housing with pressure switch. Additional Information Heater Type - Flow-Thru Heater Style -...

This part is a Cal Spa Gray 3" Storm Jet Insert Pentair Cyclone Micro.. You remove this jet but twisting the face hard left.. It will push itself out..

This part is a Cal Spa Gray 3 1/2" Jet Insert Maxi Flow Reg Face - 2001 American Products.. You remove this jet but taking a small flat screw driver and sliding the tab found inside the face around the edge out and grabbing the face and sliding the...