Complete Heaters

Balboa InstrumentsStainless steel replacement heater assembly. 2" x 15" manifold with1/8"npt pressure switch tap, does not include tailpieces

This part is a Heater, FloThru, Universal Fit, 15" x 2", 230v, 4.0kW..  This heater will work in place of the following heaters: 1563-08 , 20-00245 , 20-00317 , 20-00318 , 20-00319 , 20-00324 , 20-00433 , 20-00434 , 20-00454 , 26-0034 , 26-0036-R1C...

No Longer Available.. Leisure Bay&OthersVertical heater assy, 1" barb inlet/outlet same side, 3" x 9" dimensions, Rated at 5.5kW/240v. Similar to Hurricane except that the 1/8"npt pressure switch tap is located between the 1" ports and a temp...

This part is a Complete Trombone Heater that is about 23" X 10" X 15" Squareback 3-Wire with Built in Thermal Cut-Out. Includes Titanium Heater Element and Hi-Limit Disk. This heater fits a lot of different brands of tubs and there is a list below of...

You are buying a Complete Replacement 4.0KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tube, Element, Pressure Switch, Split nuts, pigtail wires and Gaskets. The new version of this heater includes...

Stainless steel aftermarket replacement heater assembly that fits systems that use dual sensor technology. 2" x 15" with two thd taps for the sensor assembly rated at 5.5kW/240v. Replacement sensors sold separately.

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

Stainless steel aftermarket replacement heater assembly that comes with (2) M7 Sensors and and the Split Nuts and Gaskets.. It is a direct fit replacement for Most Balboa Systems with M7 Sensors.   Heater Application Balboa Water...

IN.XM-1-8-IR-PA-1IN.THERMIntelligent remote water heating system designed to be totally maintenance free.Separated from the pack, in.therm is an intelligent 4.0kW remote heater that integrates electronics in its power box. It includes a built-in...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

Balboa Water GroupStainless steel replacement heater assembly, 4.0kW, 230v or 115v, the inside Diamater of the tube is 2" and the overall length of the tube is 15" not including the split nuts on each end. This comeplete heater includes M7 sensors,...