Electronic Control Systems and Parts

This part is a Circuit Board, Keys Backyard, Balboa, ICON10, Lite Leader, 8 Pin Phone Cable... This board will replace boards with the part numbers: 3-60-0082 , 52235 , ICON 10   Balboa Water Group Lite Leader Circuit Board. Supports 2...

This part is a Pressure or Flow Switch for a Hayward HeatPro Pool Heater.. some of the heater model numbers this fits are HP20654T, HP21104TC, HP21404T, HP21124T.. NOte: This pressure switch is not a thread in type it is made be mounted through a hole...

This part is a Balboa Circuit board replacement for a Master Spa 54418 EL8000 Mach 3 system it is a new board and can be found under several different numbers..   Master Spa Circuit Board Chip...

This part is a Balboa Circuit board for an EL2000 Mach 3 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug.. Circuit Board Application  ...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a VS501SZ Board that operates (2) Jet pumps or (1) Pump and Blower, Light and a Circulation Pump if equipped.. This board is used mostly with (6-7) Button Topsides.. Circuit Board Application    Balboa Water GroupCircuit...

This part is a Temperature and Hi-Limit Sensor that fits some ACC SmartTouch control systems there is one sensor bulb is 1/4" Diameter and it uses (2) 2-pin connectors.. Fits most ACC Smartouch and Epack control systems regardless of year.

This part is a Temp and Hi-Limit sensor set for all ACC Smartouch and Epack control systems regardless of year. Original design (Pictured) was one individual sensor for the temp and another for the hi-limit. New style sensor will have one probe, but two...

This part is a Used New Style 3 Lug Terminal Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one or two legs and if the soldered on finger terminals are good on the board you can replace this part and not buy a...

This part is a Balboa Circuit board for an EL2000 Mach 2 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug.. Circuit Board Application    Balboa...

In this video The Spa Guy tells you the basics about diagnosing and replacing a M7 sensor on a Balboa Board.  Click this link for the m7 sensors on this site: M7 Sensor #sparepair #hottubrepair #spaguy...