Hot Tub Parts of America

Female quick disconnect for Balboa plug and click heaters. This 6" adapter connects to the heater terminals on your circuit board and then plugs into the male 25263 adapter from your heater on the...

Balboa VS100 circuit board and heater kit made to replace the discontinued VS100 spa pack and the previous versions of their retro-fit kits. This circuit board will fit into any previous VS100 or...

This part is a Circuit Board, Balboa, VS501Z, Duplex Digital, 8 Pin Phone Cable w/Circ Option.. As of 2024 new VS501 circuit boards will come with the plug and click female heater adapter installed...

This part is a Balboa, E7, (7) Button, Topside, Standard Digital, (2) Pump & Blower, Light...This panel replaces all Serial Standard Digital products. It also utilizes the Cat 5 phone type...

This part is a 5 Position 50 Amp Terminal Block found in Balboa Lite Leader Packs and some others..  Terminal Type    Terminal BlockTerminal Style    Terminal...

You are buying an Oval Topside that is a Balboa E8 with a Cat 5 Type plug end that uses only 7 of the buttons. This means it is capable of having 8 buttons but you will find this sometimes with...

The BP Series WiFi Module Kit allows you to access your hot tub via a direct connection anywhere in the local proximity of your tub, anywhere in your house that you can connect to your local...

This Baptismal Auto Fill Kit, Hydroquip BES/BCS Series, w/ Interface Module, Water Level (Float) Assembly is manufactured by Hydro-Quip.  Hydro Quip Baptistery Equipment Auto Level Kit (FLOAT...

This part is a Barb Adapter 3/4" Barb x 3/4" Street or 1/2" Inside Slip.. The means a 3/4" Inside Diameter tube would glue over the barb side while a 1/2" pipe which is 3/4" Outside Diameter would...

Barb Adapter 3/4" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/4" ID tube would be glued over the barb.

Barb Adapter 3/8" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/8" ID tube would be glued over the barb.

This kit is an Air Bleeder Barbed Plug Connect Kit that features a Barbed Plug that is 1/4" MPT x 3/8" Barb, (1) 3/8" x 3/8" Barbed Coupler, 4" of 3/8" clear tubing and Silicon sealer usually used on...