Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors

(2 reviews) Write a Review
SKU:
HTP35-125-2600X2
Shipping:
Calculated at Checkout
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
  • Set of (2) Motor Bearing Deluxe High Quality 6203 Fits most but not all motors
MSRP: $39.99
$24.99
— You save $15.00

Description

This part is a set of (2) Bearings that fit most motors that are used in hot tubs, this bearing is 17MM ID. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric NOTE: Installing bearings requires special tools and special knowledge therefore this kit is not for someone who has never installed bearings before. Bearing tools not included!! Measure your bearing before ordering since there are many different bearings. 

 

If the center hole of you bearing is 15.9MM you can find those here: 15.9MM Bearing

View AllClose

2 Reviews

  • 5
    Replacement bearings perfect fit

    Posted by William Harlin on Apr 19th 2019

    Ordered the pump motor bearings based on dimensions shown on web site. Fit perfectly. Actually only the one near the seal was worn, but replaced both while it was torn down. I should have replaced it when changing the seal several months ago, but did not realize it was bad until the motor noise increased above normal level. Spa Guy videos on changing the seal and bearings were great!

  • 5
    Back In Hot Water

    Posted by Dennis Whitehead on Aug 27th 2018

    With the help of the repair videos and the new parts sent, my Dr. Wellness Hot Tub is working like new again. I previously ordered the impeller kit, but luckily, I had not installed it before the bearing issue made itself known. I did add a nitron lined washer to the shaft to prevent water ever getting to the front bearing ever again. I do believe it is a much needed addition and will go a long way to preventing further bearing problems.

View AllClose