Waterway Pump Impellers & Parts

This is a Kit that features (1) PS-1000 Seal and (2) Bearings that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place. This Seal is used in Waterway Wet...

This is a Kit that features (1) PS-1000 Seal and (1) Bearing that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place.  This Seal is used in Waterway Wet...

This part is a PS-1000 Seal Kit with Silicon and a Seal Install Tool. This Seal is used Primarily in Waterway Brand Wet Ends. It is 1 3/8" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic...

This part is a (BEST) Silicon Carbide Salt Resistant Verison of a PS-1000 Seal. NOTE: This Seal does not fit a Waterway Viper or EX2 Wet End.. Silicon Carbide’s exceptional wear and chemical resistance, enhanced dry running capability and high...

This impeller is no longer avaialve from the manufacturer but the one at this link wil work in its place: Impeller, Aqua-Flo, XP3, 4.0hp, For XP3 Pump 2 1/2" x 2 1/2" Wet End This part is a Waterway Viper Pump 4.0 Impeller exclusively for A Waterway...

Tnei part is no longer available you can only order the complete wet end found Here: Wet End, Waterway, Uni-Might, Iron-Might, 1.0HP, 1-1/2", 48 frame, 1.4A/115v Waterway Iron Might Circulation Pump Impeller for 1/8HP Pump Closed face impeller made...

This Kit is an 1HP Impeller for an Executive 48 Frame Wet End up to 1HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 2.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 2.0hp (or greater) thru bolt motor. Shaft seal sold...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 3.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 3.0hp (or greater) thru bolt motor. Shaft seal sold...

This Wear Ring only fits Waterway Executive 1, 2, or 3HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 1-1/16" thick from front to back... If you have a Waterway Executive 4 or 5 Horsepower Wet End it will require a different wear ring that...

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

Waterway Hi-Flo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 1.5hp, it is used in a Waterway Hi-Flo pump wet end, and must be installed on a 1.5hp (or greater) thru bolt motor. Shaft seal...