Aqua-Flo 230V 56 Frame Pumps

In this Video the Spa Guy show you how to install a 200 seal in an Aqua-Flo Wet End.. This is the seal only version... For the full version look in The Spa Guy's How To Video Library.....

This video is about The Spa Guy showing You How To Remove a Stuck Pump Impeller...This technique is similar for all brands of pumps and motors... Save Save Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace a 200 style seal on an Aqua-Flo Pump and put the wet end back together... Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace Bearings on an Aqua-Flo Pump.. Bearing replacement is similar for all motors.. Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Clean a Rusty Shaft on an Aqua-Flo Pump.. This process is similar for all brand pumps.. Save Save Save Save Save

This set is a Set of (2) 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union recieves a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the...

This Pump is a 56Frame 230V 2 Speed with a 2.0 HP Wet End that features a 2" x 2" inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 10.0 and low speed is 3.5 Amps.. HTP34-402-5252 Pump,Aqua Flo XP2e,3...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 4-5HP 56 frame 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3"...

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56 frame...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 56 frame XP2e 3.0HP 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...

This part is a 2" Pump Union Split Nut Repair Kit which includes the split nut and (2) Screws for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the Threaded Side and mounts to the existing Pump Union Body...