Pumps and Related Parts

This part is a Run Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a run capacitor concern you will find high amp draw, overheating, Noise and other concerns. This type of capacitor is really hard to dioagnose unless it is not...

This part is a Starter Capacitor that fits many 230V Pump Motors. When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw driver to the shaft in the back and spinning it or...

This item is a 1/4" Air Bleeder Plug with coarse threads that can be found on the old style of a StaRite Dura-Jet DJ Series Wetends only. The head of this plug will break off and leave the threads in the wet end face. You can take a flat screw driver and...

Grundfos Circulating Pump 230V with 1" Barbs... In my opinion this is a better pump than the Laing Brand... Spa Guy Note: If you are using this pump to convert from a Laing you will need this Conversion Kit If you want the same kit but need Glue Click...

This Listing is for a Waterway Executive 56fr 2 Speed 230V 3 HP 2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps. This unit features a 2" X 2" Executive Wet End that can be moved from the 12 O'clock position to...

This part is a Starter Capacitor that fits many 115V Pump Motors. Start Capacitor, 161-193 MFD, 115v, 1-7/16" x 2-3/4" When diagnosing pumps for a no start condition where it is powered up but just hums you can hand spin start the motor by taking a screw...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... There are (2) Different versions of the...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This is a Flat Gasket for 2" Pump or Heater Union Extra Thick 1/4". It is a 2 7/8" Outside Diameter and 2 1/8" Inside Diameter.

Grundfos Circulating Pump 115V with 1" Barbs... In my opinion this is a better pump than the Laing Brand... Spa Guy Note: If you are using this pump to convert from a Laing you will need this Conversion Kit If you want the same kit but need Glue Click...

This Seal Kit PS-3868 Seal is an Upgraded Better Viton Carbon Graphite Version of the PS-201 Seal used Primarily in Vico & Sta-Rite Wetends.It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber...

This part is a Salt/Ozone Resistant PS-3865 which is the upgraded Better version Viton Carbon Graphite version of the PS-1000 Seal. This Seal is used Primarily in Waterway Brand Wet Ends. NOTE: This Seal does not fit a Waterway Viper or EX2 Wet End.. It...