Pumps and Related Parts

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56 frame...

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

 Vico Ultima Ultra Flo or Ultra Jet Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 4.0hp,which is between 12 and 14 Amps.. it is used in an Ultima, Ultra Jet and/or Ultra Flo pump wet end, and must be...

This is a XP2e 2.0HP Impeller.. The Impeller has a 2 5/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 2.0HP Motor would be about 10.0 Amps on high speed at 230V or 16.0 Amps on High at 115V. See the links below for seals, bearing and other parts...

Run Capacitor2"dia x 3-3/4"hgt

This is a .75HP or 3/4HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .75HP Motor that has about 7.0 Amps on High Speed at 230V and 7-8.0 Amps at 115V. This Impeller fits between the Face and the...

This part is a Stationary Switch that fits in the back of some A. O. Smith Motors also Century and Regal Beloit.. This switch is about 2" wide, 2 1/2" Long and 1 3/8" Tall.. Motor Brand    A.O.Smith/Regal BeloitMotor Parts...

Vico, Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 3.0hp,which would be 8-10.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 2.0hp (or greater) thru bolt motor.  Click here for...

Gemini Plus II Pump Complete with Wet End and Air Switch... 1 1/2" X 1 1/2" which measures about 2 3/8" across the threads.. Specifications are 1.5 HP 115Volt 12.5Amps... For high flow bath jet systems Length = 12-11/16" Width =...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...

This Pump is a 48Frame 230V 2 Speed with a 1.5 HP Wet End that features a 2" x 2" inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 7.7 and low speed is 2.2 Amps..   Spa Pump Features: Fine tuned...