Parts by Group

This Kit is features a 3HP Impeller, (2) Standard Bearings and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 3HP Motor. This Impeller fits between the...

This Kit is features a 3HP Impeller, (1) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 3HP Motor. This Impeller fits between the Face...

You are purchasing a 2HP Impeller, (1) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face...

You are purchasing a 2HP Impeller, (2) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face...

You are purchasing a 1HP Impeller, (2) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face...

You are purchasing a 1HP Impeller, (1) Standard Bearing and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face...

This 1 Horse Power 10.3/3.8 Amp (2) Speed 48 Frame Complete Pump is a Guangdong LX Brand Pump. These pumps usually have the part number 48WUA1001C-II on the label for a Watkins Version. Watch the video for instruction on how to Identify...

This part is a Wear Ring that only fits Guangdong LX or LP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 3/4" thick from front to back... WUA Pumps.. Note: When Replacing some original LX Pump faces the wear ring was built into the face....

This is a 5-1/4" FLUIDIX-INTELLI-JET WITH ESCUTCHEON for Sundance Hot Tubs.. This jet is very specific to Sundance brand hot tubs only do not order for another brand.. Please Look closely at the pictures with measurements to be sure before ordering....

This Part is a 1HP Impeller that fits an E-Series 48 Frame 1 1/2" Center discharge Wet End which is found in hot tubs some but on Above Ground pool pumps many times. This Impeller fits between the Face and the Volute of an E-Series Wet End. I...

This pump is a rated 5HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This pump is a rated 4HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...