Jacuzzi Whirlpool Hot Tub and Bath Parts

This Parts kit is an Almond Color Jacuzzi Whirlpool BMH Jet Retrofit kit with the plumbing for a 1/2" or 3/4" Connection.. The Hole Size this jet fits is 2"...  Hole Size 2" Jets Complete Jet Complete Air Connection...

This item is a 2 1/2"" Heater Union Tailpiece with a Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. If you need a gasket for this union click this link.. 2 1/2"...

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union. The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side. This part is used on Heaters that are...

Replacement Part for the Front Load Skim filter

NOTE: This Complete Heater Assembly has just come available I have them in stock... This part is a 5.5KW Spa Heater Complete Assembly found in a Jacuzzi Whirlpool Control System includes the Element, Pressure Switch, new Titanium...

Jacuzzi J-Series Wet End Kit Bottom Suction, center discharge, 2"mjt, 48 frame wet end by Jacuzzi/Carvin. This wet end is used with a 1.0hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The complete wet end...

This part is a Impeller, Jacuzzi, J Pump, 1.0hp, 48FR, J Series, JCM Series, K Series, KM Series.. This is found on a Wet End that has a face like I show in the Photo Section only..  Impeller Type Closed Face Impeller Diameter...

This part is an Jacuzzi J Pump Impeller Wear Ring.. It measures about 1 15/16" ID and 2 7/16" to the outermost OD..  Fits the following pumps: Cygnet Series - All Horsepowers J, JCM, K and KM Series - All Horsepowers L, LC, LCUN2,...

This filter is 9 3/4" Tall x 4 5/8" Wide and is closed on the top and has a 1 1/2" mpt thin threaded nipple that measures about 1 13/16" across the threads. This filter fits some of the Jacuzzi Whirlpool hot tubs that are found under the names Jacuzzi...

This part is a Jacuzzi® J Pump Style Pump Union that can be used on 1 1/2" or 2" Plumbing systems. This union can receive a 1 1/2" plumbing part inside the back of the union or a 2" Plumbing part glued to the outside of the...

This part is a 2 1/2" Therm Style Pump or Heater Union Gasket Only for use with a 2 1/2" Heater or Pump Union. If your heater or Pump is 2 1/2" this part could be correct we offer (2) different sizes of 2 1/2" gaskets so you need to verify your...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...