Four Winds Brand Hot Tub Parts

This New Old Stock part is a Complete Hot Tub Spa Part Gray 11" Waterfall Assembly 3 Hole Style Graphite Gray Hole size is about 1 3/4" each.. You will get a 90 degree 3/4' Barb with the waterfall....

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This...

Balboa Water GroupStainless steel replacement heater assembly, 5.5kW/230v, 2" x 15". Includes a pressure switch, Hi Limit Sensor on the right side. Made for Balboa Value and Balboa LE control systems...

This part is no longer available.This Part is No Longer available.. This 1" CMP Waterfall Control Plunger Replacement Kit that includes the Cap, Handle, PLunger Assembly and o-rings..<

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade..

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade..

This part is a 100 Square Foot Filter Cartridge that is 17 13/16" Tall x 6-9/16" Wide with a 2 3/8" Hole on Top and Bottom it can be found in some H2O or Four Winds Swim Spas and many other brands as...

Universal pressure switch cable for the Gecko S-Class, SSPA, M-Class, MSPA and TSPA spa packs and circuit boards. This cable has two connectors on one end to connect to the pressure switch and a red...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Jets, Light and to the right is...

This part is a Black 3 1/4" Long Catalina Spa Diverter Handle Knob only. This Diverter Knob mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap...

This part is a Hot Tub Pillow that is 9 1/2" x 4 1/4"  and 6-1/2" between the Tabs it fits a variety of brands some are out of business. It fits some Infinity, Raindance, Serenity, Premier, Serenity,...