Dynasty Hot Tub Parts

This Kit is a 90° 2" Pump Union To Plumbing Connect Kit found in many Hot Tubs. The Pump Union which measures about 3" Inside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" Street X Slip 90° fitting on the slip side of...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Bottom Physical Dimension 1-1/4" Bottom Style Female SAE Thread Diameter 4-3/4" Length 11-3/8" Media Type 3oz Square Footage 30...

This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Dynasty Bahama Tubs and others. If you have the shorter version of this filter which is 9 1/4"...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts,...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This video is about The Spa Guy showing you how to replace a freeze damaged pump pressure side pump union , slice to the flex pipe where it was freeze damaged... #dynastyspa #dynastyhottub    #sparepair #hottubrepair ...

This Kit is a 45° 2" Pump Union To Plumbing Glue Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This Kit is a 45° 2" Pump Union To Plumbing Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This kit is a Set of (2) Air Bleeder barbed plugs,(2) 3/8" x 3/8" Barb couplers, (2) 4" long pieces of 3/8" Tubing and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up...

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...