Cal Spa Hot Tub Parts

This kit is a Set Of (4) Bolts and Grommets For A Cal Spa Hot Tub Front Access Panel Door.  The Bolt is 2" In Length And The Grommet Has 3/4" Diameter.  

This part is a Cal Spa Safety Suction Tee Fitting that has a 2" Pump Union that would measure about 3" Inside Diameter X 2" Slip Fitting that is 2 3/8" Inside Diameter with a 1/8" MPT Tap on the top to receive a Safety Suction on Top.. Note: The Cal Spa...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...

This item is a (6) Way Barbed Coupling used to couple 3/4" main hoses and 3/8" ID hose together. 3/4 Inch Barb X 3/4 Inch Barb through and (3) tees Barb Coupling 3/8" barb and 3/8" barb... This part is used on pump bleeder systems many time where the...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply...

This part is a Set of 4" Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements to transfer voltage from the circuit board to your heater. Uses a 10 gauge wire...

This Part is a  Cal Spa 1" Spa Hot Tub Complete Air Valve "Teardrop Style". The Valve Tear Drop Cap Width is approx. 3" and the Hole size in the tube would be 1 5/8" with a 1" slip plumbing commention on the bottom..   For help please see our...

You are buying a Cal Spa 7000 or 9000 Heater M7 foam type Sensor. This Sensor comes with the wire, Connector, and The foam sensor. It DOES NOT include the tube, the tube side mount or the pull ties. When this sensor is bad it will generally cause a SN...

This part is a Cal Spa 1" Spa Hot Tub Air Valve " Cap Only". The Valve Tear Drop Cap Width is approx. 3" and the Hole in the Cap is approx. 1/4". Compare the measurements to be sure this is correct. NOTE: This listing is for the Cap only all other...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have only (1) left.. This is the Reverse Side Closed face impeller made for the Power-Right PR420-5R Dually spa pumps. Seals & kits for this Impeller can be found here: 201...