PC Control Boards

This part is a Circuit Board, Sundance/Jacuzzi, LX-10, Rev 3.56+, (1999 +), w/3 Big Relays, 1-Pump, w/Circ Pump.   It will replace several different boards including but not limited...

This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups.. This part is found in some Jacuzzi Premium J-220, J-210, J-315, J-310, 2004 J-325, and 2008+ J-325 models and some Sundance 800 or 850 systems....

This circuit board is no longer available. Artesian reccomends using the retro-fit control system found here. Artesian Spas Circuit Board - MBP501Board, Artesian Spa, MBP501 (Set-Up #1), P1 (1SP), P2 (1SP), 24Hr Circ Pump, 4 Pin Molex4 Pin Molex...

This part is a 33-0612-08 replacement circuit board that operates (2) Jet pumps or (1) Pump and Blower, Light and a Circulation Pump if equipped on some Artesian or South Seas Hot Tubs.. As of 2024 new VS501 circuit boards will come with the plug and...

This part is a New Balboa 2000LE M7 Spa Hot Tub Board. Watch the video for more information including some diagnostic tips.. This board does not use a pressure switch it has (2) M7 sensors.   Board is used with an E7 Topside and can run up to...

This part is aNew Balboa MS1500 Spa Hot Tub Board found in Master Spa Brand hot tubs. MASTER SPAS CIRCUIT BOARD 8 PIN PHONE STYLE CONNECTION    CHIP NUMBER: MS1500R1(X)    REPLACES X801025   Below Is a List of related...

This part is a VS504SZ Board that operates (2) Jet pumps and a Blower Or 3 Pumps..  Light and a Circulation Pump if equipped.. This board is used mostly with (6-7) Button Topsides.. Circuit Board Application Balboa Water...

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems for the Blower circuit, w/10 Amp Fuse, w/Cables.. Please Note: Circuit boards are a final sale and cannot be returned Circuit Board Control Type Spa Control Circuit Board...

This part is a Balboa Circuit board for an BP2000-G1 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug.. The original board number would have been 56380 this...

This part is a Balboa BP series BP501G3 (Set-Up #1-3), works with TP Series Top Side Panel, Pump1-Blower/Pump2, 4 Pin Molex Connector. This board is used with TP Topsides only..and is commonly paired with the TP600 panel. Original versions of this...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...