Circuit Boards

This part is a Balboa SUV Board.. There are many part numbers you will find on your old board to cross to this board..One thing that goes wrong with this particular board is the transformer tabs or fingers will break in two causing the board not to power...

Universal Balboa circuit board used to replace many OEM boards that are discontinued. This board will give you all the same functionality as your original. Only differences may be default set temp, default filtration cycle settings etc. Can replace...

You are purchasing a New Balboa 52295 Non M7 Spa Hot Tub Board. Watch the video for more information including some diagnostic tips.. This board does use a pressure switch.   Board is used with an E7 Topside and can run up to two pumps and...

This part is a Relay, Closed Style, T-90 Type, 12vdc, Coil, 30 AmpCircuit board mounted. Use to complete simple circuit board repair. Action Coil Amps SPST 12 VDC 30amp Coil Voltage Type DC Relay/Contactor Style Relay Pole/Throw Single Pole...

This M-1 54091 circuit board is obsolete. You will need to move to a retro-fit control system. Duplex Digital and Super Digital/M-1 Replacement BoardsThis board requires a 120v power supply and can work with any DuplexDigital. It is found on the Balboa...

This relay is No Longer Available.. T90 Style Circuit Board RelayCircuit board mounted, available in various coil voltages. Use to complete simple circuit board repair Action Coil Amps SPST 18 VDC 30amp

Vita Spa OEM circuit board made by Consumer Engineering. This PGI Graphic circuit board is made to replace many older versions. This board has support for up to 3 pumps and a circ pump. Replaces L500 / LC500 / L500A / L700 / L700C / L100 / L200 / R100 /...

This circuit board has been discontinued. You will need to install a new retro-fit control system, see below for choices but be sure to verify these have the correct support for your model:Control Retrofit Kit Balboa BP7, 1 or 2 Pump/Blower ,Ozone...

Note: This board is Obsolete but you can use this board: Replacement for this Board.. This Balboa Board is a VS-500 meaning it is a one jet pump board that will run a 12V light and a Circulation Pump also if equipped... This board can be found under all...

The VS300 circuit boards have been discontinued. We now send the VS501Z circuit board which has a few more receptacles but is the same otherwise in fit and programming. This part is a VS300 Board that operates (1) Pump and Light..If your board has this...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. Measures 1-3/8" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    LE, Value...