(1) Front Bearing & 200 Seal Pump Parts Kit Fits Most Aqua-Flo Spa Pumps
$29.99 (You save $10.00)
Calculated at checkout
This is a Kit that features(1) PS-200 Seal and (2) Bearings that fit most motors that are mated to Aqua-Flo Pump Wet Ends as well as Waterway " Viper" Wet Ends, The Professor silly Juice to seal the seal.This Seal is used in Most Aqua-Flo Wet Ends but is found in others like a Waterway" Viper" Wet End.. look in our store for other seal & bearing kits. It is 1 1/4" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber part that goes into the Volute or Wet End Back is 1 1/4". The Hole in both parts is about 5/8". Note: AquaFlo, Flo-Master, XP,XP2,XP2E, FMHP,FMCP,TMCP, FMVP
To Install you should put silicon sealant on the back of the Metal part and gently push it into place. Also the rubber part can use a light coat of silicon to slide it into place in the impeller.
We offer these alone, with The Professor's Silly Juice or with an Impeller in a kit so look at my eBay store. The bearing are standard fit for most motors with Aqua-Flo Wet ends.
35-423-1020, 35-423-1022, 35-423-1019, Aqua flo, aquaflo,
Visit our eBay Store as we also offer these and other associated products and accessories for your Spa.
Please note: When you have a seal leaking in most cases you will need an impeller because the leak caused water to get into the metal shaft area that the impeller is screwed onto and expands and damages the impellor. The Hot Tub Professor offers How To Installation Videos on Seals and Impellers.
*Note: This Seal is Only Found in Waterway "Viper" and EX2 wet ends all other Waterway wet ends use a 1000 seal...