Complete Heaters

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This video is about The Spa Guy diagnosing a Breaker Tripping on a Hot Tub With Hydro-Quip Controls... How To Replace the Heater Element and final diagnostic verification of operation.... Save

This video is about The Spa Guy showing How To Remove a Heater Element where the nuts are spinning in the tube and will not turn off...... it is a similar process on all brands... Save

You are buying a 4.0KW Heater Complete Assembly includes Tube, Element, Metal Case and connecting wires. This unit features a high limit holding tab and a port for the pressure switchThis Heater Fits Cal Spa Hot Tubs and Is a Perfect replacement for...

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union with Gasket that matches Union.   The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side...

This part is a 5.5KW Titanium Heater Complete Assembly includes Tube, Element, Metal Case and connecting wires. This unit features a high limit holding tab and a port for the pressure switchThis Heater Fits Cal Spa Hot Tubs and Is a Perfect replacement...

This part is a 5.5KW Heater Complete Assembly includes Tube, Element, M7 Sensors, Split nuts and Gaskets. This unit features a 5,5Kw Element, Tube with (2) M7 Sensors on either end with (2) Split Nuts and gaskets. I also offer this heater and tube...

You are buying a Complete Replacement 4.0KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tub, Element, Pressure Switch, Split nuts and Gaskets. NOTE: If you have the old style SSPA board with the...

You are buying a Complete Replacement 5.5KW Heater Assembly that fits a Gecko SSPA or Spa Builders Pack. This Heater Assembly includes the Tub, Element, Pressure Switch, Split nuts and Gaskets. NOTE: If you have the old style SSPA board with the...

Sundance SpasVertical heater assembly 3-1/2" x 13" with 3/4" barb x 3/4" 90° barb inlet/outlets. Rated at 5.5kW/240v. Purchase of a foam wrap jacket is recommended when purchasing manifold

Cal Spas 1990-1992No pressure switch tap. Stainless steel replacement heater assembly 1-1/2" x 15-3/4" manifold includes 5.5kW/240v element and split nuts with tailpiecesNote: Element replacement is not recommended for this manifold

Arctic Spas ReplacementStainless steel replacement flow thru, L shaped heater assembly with a 5.5kW/230v incoloy element. This is an aftermarket heater made for use on Arctic Spas. Heater gaskets, and tailpieces are included. Pressure switch sold...