Diverter Valve Parts

Diverter stem for the Waterway Top Access 1" diverter valves. This style diverter stem is not as common and is used in Waterway diverter valves that were designated as Single Side Outlet.  Please review the pictures to be sure you have the correct...

This item is a 6 Spoke 3 5/8" Wide Diverter Knob for a 1" Waterfall or Neck Jet Control.. The outside measurement is about 3 5/8" and the center hole is about 1/2".. NOTE: There is an Air Control version of this know that measures about 3 1/4" wide...

This parts is an Upgraded Starfire Style 4" Starfire Black Knob Only.  The Valve this part fits is found on Newer Cal Spa but will fit many other brands too.  Compare the measurements to be sure this is correct.   This listing...

This part is a Handle Knob for a 5" Wide Master Spa Twilight Series Diverter Valve. This Kit comes with the 5" Six Spoke Handle. The Valve these parts fit is found on Master Spa Twilight Series but will fit many other brands too...

This part is a Cal Spa Silver Waterfall Control Cap 2 9/16" Wide Teardrop Style  only.  This Waterfall Cap Slides on the Diverter Valve Stem is used to operate the Wateffall Control Valve and is for Cal Spas.   This Part is...

This part is a 2 1/2" Titanium colored 1" Waterfall or Neck Jet Control Cap.  This Cap Screws onto the Control Body that measures about 1 3/4" wide and Slides over the Diverter Valve Stem is used to operate a Waterfall...

This Kit is an Marquis Spa Hot Tub Gray, O-Ring Kit fits 4" Diverter Cap with 3" Style Thread.  This Diverter handle Slides on the Diverter Valve Stem is used to operate the Diverter Valve. The Cap screws down onto the existing diverter...

This part is a 5" Black Round with Starfish Shaped Cuts Diverter Knob with no Center logo. The Square under the cap that fits on the stem measures 7/16" inside.. This knob has 602-3880 cast in the underside.. This Diverter Knob Handle Slides on the...

This part is a Clear 50 Rib Buttress 3 1/2" Spa Diverter Cap only.  It measures 3 1/2" Edge to edge and the thread width is about 2 3/4" wide.. This Diverter Cap mounts on top of the Diverter Valve with the Stem sticking through then a...

This part is a Clear 18 Rib Orion 3 5/8" Spa Diverter Cap only.  This cap is thicker at 13/16" Thick and most caps are 23/32" thick.. It measures 3 5/8" Edge to edge and the thread width is about 2 3/4" wide.. This Diverter Cap mounts on top...

This part is a Gray Textured 3 3/4" Spa Diverter Cap only.  This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the...

This part is a Gray Smooth 5 Scallop 3 3/4" Spa Diverter Cap only.  This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the...