Valves All Types Ball, Check, Diverter, etc...

This part is a Drain Cap with a Pull Handle for a Waterway Brand On/Off Valve, Water Hose Cap... Note: Colors can vary Black, White or Green NOTE: This Cap will only work on Waterway Brand Drains do not order for any other brand.. I put an example of...

This Kit is an Upgraded 3 3/4" Wide Buttress Silver Diverter Valve Cap, Valve Stem with a Swoosh Black Knob and O-Ring Kit. This Kit comes with The Swoosh Handle, Valve Stem, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring...

This Kit is an Upgraded  3 3/4" Wide Buttress Diverter Valve Cap with a Black Knob and O-Ring Kit. This Kit comes with The Teardrop Handle, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on...

This part is a Hoss 2" Slip X 2" Slip Slice Gate Valve with Keeper. The Valve recieves a 2" pipe or fitting (Which is about 2 3/8" Inside Diameter) on both sides. This part is used in hot tubs to stop the water so you could service the heater or the...

This Jet Body Connect Kit is (6") of 3/4" Clear Tubing with (1) 3/4" x 3/4" Smooth Barbed Coupler and (2) 3/4" Clamps, (4") of 3/8" Clear Tubing with (1) 3/8" x 3/8" Barbed Coupler and 4oz of Blue Glue.. This kit is used to Connect the 3/4" Barbed...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" slip or 1" Street, Gray, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one...

This New Old Stock part is a Complete Hot Tub Spa Part Clear 7 5/8" Waterfall Assembly 2 Hole Style Hole size is about 1" each.. You will get (2) 90 degree 1/2' Slip fittings with the waterfall.. If you need this waterfall to be barbed you will need 2...

This part is an Air Check Valve Kit with a 1" Air Check Valve a (4) 3/8" Barb Transistion Manifold with (2) Plugs that can be down to (2) Barbs and a 4oz can of glue to glue it all together. This valve is used above the water line to allow constant...

This part is an Air Check Valve with a 1" Slip Fittings on one end. This valve is used above the water line to allow constant air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. This type Check...

This part is a Stem Washer for a Gate Valve on 2003 and under Sundance® Hot Tub Diverter. This Diverter Stem washer Slides onto the Diverter top under the cap.   Click this link for other Sundance Diverter Parts: Sundance® Diverter...

This part is a Drain Valve with 1/2" inch Slip Glue In style fitting.. If you need to make this a barb style click here for the kit: 3/4" Tubing Barb Connect Kit with Glue, 3/4" Barb x 3/4" Smooth Barb with Clamps and Tubing For the Large Valve Click...

This part is a LA Spa Gray Odd Shaped Diverter Handle 5 1/2" x 2 1/8".