Digital Electronic Topside Controls

This part is a Four Button Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet, Jet.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is a Three Button Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is an Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet, Aux.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is a Overlay, K-52, Sspa-Mp, Two Pump, Bahama Logo for Dynasty Brand Hot Tubs.. If you need the control panel for this overlay click here: Topside Control, K-52, Curved, Pack, No Overlay, 11010

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems for the Blower circuit, w/10 Amp Fuse, w/Cables.. Please Note: Circuit boards are a final sale and cannot be returned Circuit Board Control Type Spa Control Circuit Board...

This part is a Balboa Heater M7 Sensor with a 82" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This part is a Balboa Heater M7 Sensor with a 46" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs.

This part is a Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.  Note: This sensor does not have the nut and washer on it so it will only work with Jacuzzi Premium hot tubs..   Application Balboa...