Topside Controls (Control Buttons)

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater   This part is a single Jumper Strap to connect the heater to the circuit board on Balboa B2DG and B240 Systems. Requires two per...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Jet, Jet, Temp and Light left to right. Make sure your old topside does not have a raise area for...

This part is a Control Box Cover that fits Balboa VS or GS Series Control boxes only..

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is no longer available, but we do have a replacement here: Hydroquip / Gecko ECO-1 Crescent Shaped 4 Button Topside Control Panel   This part is a Eco Series Hydro-Quip, Eco 5, 4 Button, (1) Pump, Light, Aux, Small Rectangle, 10ft...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Blower, Jet, Temp and Light left to right. This Overlay can be used to replace your original...

This part is a 8 button Overlay that fits TSC-4, K-4 control panels systems set up with 2 pumps. This Overlay features 8 buttons.. If you are looking for the complete Topside Click this Link: Topside, Gecko TSC-4,K-4, 8 Button, 2 Pump, Direct...

This part is a 10 button Overlay that fits TSC-4, K-4 control panels for MSPA systems set up with three pumps. This Overlay features 10 buttons.. If you are looking for the complete Topside Click this Link: Topside, Gecko TSC-4,K-4, 10 Button, 3 Pump,...

This part is an Overlay for a Balboa 8 Button Topside that is called an E8. The topside it fits is sometimes called a ML700 or E8 and features (2) Pumps, Blower, Light, Temp Up & Down, Time, Mode/Prog.. Complete Topside part number is here: Topside,...

This part is (1) 1/8"x 1/8" X 1/8" Barbed Tee In-line Air Bleed that fits 1/8" OD , 3/16" ID Clear Hose on each side. These Will prevent very sensitive air switches from randomly activating due to thermal expansion of air and water vapor..  

This part is a Thermostat Replacement Knob used to set the temperature on 2, 3 or 4 Button Analog / Air  Command Center Topside Controls made by Tecmark,  sometimes called a Command Center..   Manufacturer Tecmark Model Command...

This part is an Overlay for a 2 Button without a Temperature Display Analog Topside Control, Air, Tecmark,  sometimes called a Command Center.. This type topside Overlay can be found on Jacuzzi Whirlpool, Blue Ridge, Gatsby and many other brands...