Topside Controls (Control Buttons)

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Jets, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa B2DG and B240 Systems.   Circuit Board Application    Balboa Water GroupCircuit Board Model    B2DG, B240Circuit Board...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Jet, Jet, Temp and Light left to right. Make sure your old topside does not have a raise area for...

This part is a Control Box Cover that fits Balboa VS or GS Series Control boxes only..

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is no longer available, but we do have a replacement here: Hydroquip / Gecko ECO-1 Crescent Shaped 4 Button Topside Control Panel   This part is a Eco Series Hydro-Quip, Eco 5, 4 Button, (1) Pump, Light, Aux, Small Rectangle, 10ft...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Blower, Jet, Temp and Light left to right. This Overlay can be used to replace your original...

This part is a 8 button Overlay that fits TSC-4, K-4 control panels systems set up with 2 pumps. This Overlay features 8 buttons.. If you are looking for the complete Topside Click this Link: Topside, Gecko TSC-4,K-4, 8 Button, 2 Pump, Direct...

This part is a 10 button Overlay that fits TSC-4, K-4 control panels for MSPA systems set up with three pumps. This Overlay features 10 buttons.. If you are looking for the complete Topside Click this Link: Topside, Gecko TSC-4,K-4, 10 Button, 3 Pump,...

This part is an Overlay for a Balboa 8 Button Topside that is called an E8. The topside it fits is sometimes called a ML700 or E8 and features (2) Pumps, Blower, Light, Temp Up & Down, Time, Mode/Prog.. Complete Topside part number is here: Topside,...

This part is (1) 1/8"x 1/8" X 1/8" Barbed Tee In-line Air Bleed that fits 1/8" OD , 3/16" ID Clear Hose on each side. These Will prevent very sensitive air switches from randomly activating due to thermal expansion of air and water vapor..