Wet End Pump Parts

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434 Type Standard Spa Brands Sundance/Jacuzzi

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This is a Set of 2X Universal 1 1/2" Pump Union Gasket/O-Ring Kit. 6 Items total..  There are three possible sizes on a...

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This is a Universal 1 1/2" Pump Union Gasket/O-Ring Kit. There are three possible sizes on a 1 1/2" Pump union measuring in the...

This Item is a Wear Ring, fits LX 1431501-03 Wet End Only. It may have a Vendor Code 3536 on the LX Brand Pump. These pumps usually have the part number 1431501-03 on the label for the 3536 Version. NOTE: Do Not purchase this for any other brand except...

This part is a Pump Shaft Water Slinger designed to sling water away from the motor front bearing in case of a seal leak and it fits All Brands of Hot Tub Pumps..   This part goes on the shaft before you install the wet end.. 

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

This part is a Stronger Pump Bleeder Barb that fits some Watkins Wavemaster XP2, XP2E, LX and others.. It is 1/4" Barb x 1/4"Npt and is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines....

This part is a Bleeder Barb with Silicone & O-Ring that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts &...

This part is a Bleeder Barb with O-Ring that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts & Wetends, Power-Right 9089X, 9094X,...

This part is a Pump Bleeder Barb for some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This...

This O-Ring is used on a Sta-Rite Pump, New Style Drain Plug, O-Ring, 1/2" ID, 3/32" Cross Section  Fits this style of plug only..  This plug is not included in this listing..   If you want the complete plug and O-Ring in this...

This Part is a 48 or 56 Frame Face Plate for a Jacuzzi or Sundance Intertek LX Brand Pump Wet End only this face plate uses fine thread bleeder plugs be sure to compare your old plugs to the pictures. This face has a flange inside...