Waterway Pump Impellers & Parts

This Kit is a Set of (4) Total Combination of the Two Standard Size 2" Heater or Pump Union Gasket (2) with a 2 1/2" Lip Center to Center and (2) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know...

This Kit is a Combination of the Two Standard Size 2" Heater or Pump Union Gasket (1) with a 2 1/2" Lip Center to Center and (1) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know which size you have...

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

This part is a Seal Kit for all Waterway Viper Pumps which includes a seal, install tool, (1) 1/2Oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer.    This pump uses a different seal than...

This Tool is a Die that fits all American made Hot Tub Pump shaft threads.. This fits Hot Tub Pumps only in these brands.. Waterway, Aqua-Flo, Sta-Rite, Vico and Power-Right.. Note: This will NOT for LX Intertek Motor Shaft... 

This O-Ring is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This 5 3/4" Inside Diameter O-Ring fits around the face of a Waterway HI-Flo 48 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! As you can see below it fits other pumps and filter housings as well.. Part...

Drain Plug with O-Ring for Waterway Wet Ends Fits Executive, Viper, Hi- Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman and More  We also offer the 3/8" Barb that replaces these plug in the case of using a Pump Bleeder System... This are found...

This Wear Ring only fits Waterway Executive 4 or 5HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back or some Intertek impellers... If you have a Waterway Executive 1,2 or 3 Horsepower Wet End it will require...

Face Screw for Waterway Wet Ends Fits Executive, Viper, Hi- Flo, Iron Might, Spa Flo, Supreme, Mustang, Workman and More Machine Thread, 8-32 x 5/8" , Stainless Steel

Waterway Viper Pump Face O-Ring fits around the Face of a Viper Pump exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... This pump uses a different seal than all other Waterway pumps...

Waterway Viper Pump Impeller Wear Ring exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads... This pump uses a different seal than all other Waterway pumps click here for the Seal Kit...