Vico Wet Ends Complete

Vico / Balboa 1.0 HP center discharge wetend for 48 frame motors. This wetend has 1-1/2" union connections that measure about 2-3/8" across the threads.  Note: This wet end would fit motors that have a 9 Amps on high speed at 230V or up to 14 Amps...

Vico / Balboa Water Group 1.5 HP side discharge Ultima wetend with 1.5" mbt union connections. The 1.5" union connections on this wetend have an overall diameter of 2-3/8". This wetend mounts to a 48 frame thru bolt motor with an amp range of 13.3-16.4...

This part is a Pump Shaft Water Slinger designed to sling water away from the motor front bearing in case of a seal leak and it fits All Brands of Hot Tub Pumps.. Note: This part does not fit tight on the shaft.. This is with purpose because the tight...

This Kit is a Set of (4) Total Combination of the Two Standard Size 2" Heater or Pump Union Gasket (2) with a 2 1/2" Lip Center to Center and (2) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know...

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

Red Epoxy is a new high performance, two-part, heat cured, epoxy repair kit for making permanent repairs on all metals and rigid plastics. Red Epoxy is specifically designed to exhibit a distinct color change when heat cured. Red Epoxy will provide a...

This Kit is a 2" Pump Union, Slice Valve, Spin Kit To Plumbing Connect Kit with Glue found in many Hot Tubs. The Pump Union which measures about 3" Inside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it to...

This Kit is a 2" Pump Union, Slice Valve, Spin Kit To Plumbing Connect Kit found in many Hot Tubs. The Pump Union which measures about 3" Inside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it to win it on...

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 3.0HP impeller which would fit a motor that has 10.0-12.0 amps at 230V and there are no 115V motors this fits.. Pump to Motor...

This Tool is a Die that fits all American made Hot Tub Pump shaft threads.. This fits Hot Tub Pumps only in these brands.. Waterway, Aqua-Flo, Sta-Rite, Vico and Power-Right.. Note: This will NOT for LX Intertek Motor Shaft... 

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This O-Ring is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...