Pump Wet Ends and Related Parts

3.0 HP impeller for the Waterway EX2 pumps assemblies. This impeller is normally found on motors with a 10.7-12.0 amp motor and fits between the Face and the Volute of an EX2 Wet End. I would advise...

Shaft seal for the Balboa / ITT Gemini Plus II bath pump. May also fit other Gemini models but we recommend comparing measurements prior to purchase since there may have been variations of this seal...

Vico / Balboa Water Group 1.5 HP side discharge Ultima wetend with 1.5" mbt union connections. The 1.5" union connections on this wetend have an overall diameter of 2-3/8". This wetend mounts to a 48...

Read This Note First!!

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Cl

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Cl

Independent Supplier & Replacement Part Notice We are

This part is a Complete Wet End for Vendor Code 3536 with pump numbers 1431601-03. 

Waterway 4 HP Hi-Flo closed faced impeller for Hi-Flo side discharge wetends that have part number 315-1160 on the rear. This impeller will fits motors that have a 230 Volt 12-13 amp rating. The...

You are buying a 1.5 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the...

This part is a Complete Verticle Mount Style Waterway Iron- Might or Uni-Might 1/8th HP Wet End that is 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Adjustable Suction Side...