Aqua-Flo 115V 48 Frame Pumps

In this video The Spa Guy shows you how to repair a broken Hot Tub Pump Union without cutting plumbing out and using an Emergency Pump Union Split Nut Kit...      #sparepair #hottubrepair  #thespaguy...

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

In this Video the Spa Guy show you how to install a 200 seal in an Aqua-Flo Wet End.. This is the seal only version... For the full version look in The Spa Guy's How To Video Library.....

This video is about The Spa Guy showing You How To Remove a Stuck Pump Impeller...This technique is similar for all brands of pumps and motors... Save Save Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace a 200 style seal on an Aqua-Flo Pump and put the wet end back together... Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace Bearings on an Aqua-Flo Pump.. Bearing replacement is similar for all motors.. Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Clean a Rusty Shaft on an Aqua-Flo Pump.. This process is similar for all brand pumps.. Save Save Save Save Save

This set is a Set of (2) 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union recieves a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the...

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56 frame...

This part is a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. See Pictures for measurements. The Union receives a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wet...

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This part is a Standard 1 1/2" Heater or Pump Union Gasket. The gasket is 2 3/8" across and fits unions that have a 1...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...