Pumps and Related Parts

Vico, Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 3.0hp,which would be 8-10.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 2.0hp (or greater) thru bolt motor.  Click here for...

Gemini Plus II Pump Complete with Wet End and Air Switch... 1 1/2" X 1 1/2" which measures about 2 3/8" across the threads.. Specifications are 1.5 HP 115Volt 12.5Amps... For high flow bath jet systems Length = 12-11/16" Width =...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...

This Pump is a 48Frame 230V 2 Speed with a 1.5 HP Wet End that features a 2" x 2" inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 7.7 and low speed is 2.2 Amps..   Spa Pump Features: Fine tuned...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This Pump is a Waterway Executive, 4.5hp, 230v, 2-spd, 48fr, 2" x 2", 12.0A/3.5A.. The 2" x 2" Threaded fittings measure about 3" across the threads..  Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter wet...

This part is a Complete 1.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 9.0 Amps on High Speed on a 230V motor or 13.0...

This part is a 4 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be...

Vico/Balboa Ultima/Ultra Flo Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 1.5hp,which is between 8 and 9 Amps.. it is used in an Ultima and/or Ultra Flo pump wet end, and must be installed on a 1...

This Pump is a Waterway Executive, 2.0hp, 230v, 2-spd, 48fr, 2" x 2".. The 2" X 2" measures about 3" across the threads.. Spa Pump Features: Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter wet end for higher...

No Longer Available.. Note: Due to a design change in the current XP2/XP2e pump wet ends, face plate or volute replacement is not suggested. Instead, replace the wet end to avoid issues with how it fits. Click for Complete Wet Ends Here.. This part is...