Pumps and Related Parts

This Wear Ring only fits Waterway Executive 1, 2, or 3HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 1-1/16" thick from front to back... If you have a Waterway Executive 4 or 5 Horsepower Wet End it will require a different wear ring that...

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 5.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This part is a Complete 2.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 11.0 Amps on High Speed on a 230V motor and not...

Seal Plate for Vico Ultima pumps. Material Type    PlasticVolute to Seal Plate Mounting Type    4 Bolts 4 NutsVolute to Seal Plate Hole Spacing    4-3/8"Seal Plate to Motor Mounting Type    48...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 4-5HP 56 frame 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3"...

The Hayward Union Adapter Assembly is no longer available With this adapter you can convert the old style Hayward 2" Thin Threaded Union to a 1 1/2" threaded fitting which = 1 7/8" O.D. standard wet end. An O-Ring does come with this fitting but if you...

This part is a Rubber Pump Motor Base Vibration Dampener for 48 and 56 frame pumps. Includes 4 soft 'washers' to isolate mounting screws from touching the motor base. This motor base mounting pad fits under any 48 frame pumps, and under most 56 frame...

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

 Vico Ultima Ultra Flo or Ultra Jet Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 4.0hp,which is between 12 and 14 Amps.. it is used in an Ultima, Ultra Jet and/or Ultra Flo pump wet end, and must be...

This is a XP2e 2.0HP Impeller.. The Impeller has a 2 5/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 2.0HP Motor would be about 10.0 Amps on high speed at 230V or 16.0 Amps on High at 115V. See the links below for seals, bearing and other parts...

Run Capacitor2"dia x 3-3/4"hgt

This is a .75HP or 3/4HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .75HP Motor that has about 7.0 Amps on High Speed at 230V and 7-8.0 Amps at 115V. This Impeller fits between the Face and the...