Pumps and Related Parts

This part is no longer available you can only get this with a complete wet end.. This part is a Face Plate with Drain Plugs and Face O-Ring that fits Aqua-FLO XP2E wet ends only on the back of the face where the wear ring will touch will measure about...

Start Capacitor1-7/16"dia x 3-7/8"hgt

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 3.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 3.0hp (or greater) thru bolt motor. Shaft seal sold...

Vico/Balboa Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico/Balboa. Rated at 4.0hp, it is used in an Ultimax pump wet end, and must be installed on a 4.0hp (or greater) thru bolt motor. Click the below links for the...

You are buying a 3 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is a Wear Ring that measures 2 5/8" inside Diameter and fits some Aqua-Flo XP2e and Xp3 Impellers except the 3.0HP Xp2e Impeller... That Impeller requires a different Wear Ring which measures 2 3/8" Inside Diameter.. Look at the chart in the...

This is a 115V Center Discharge Aqua-Flo Circulation pump with a 1 1/2" Suction and Pressure side that measures about 2 3/8" Across the threads. Circ-Master pump takes 24-hour filtration to a new level, delivering the highest GPM of any recirculation...

You are buying a 1"FTB X 1" Slip Pump Union with O-ring that matches the Union. The Union receives a 1" Inside Diameter which measures about 1 1/4" on the outside pipe or fitting on one side and then Screws to a 1" Wetend...

This part is a Gasket for an AquaFlo A, Volute, 4-13/16"ID, 5-1/2"OD, Generic.. Part Type Gasket Inside Diameter 4-13/16"id Outside Diameter 5-1/2"od

You are buying a 5 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous...

This Laing Circulation Pump is either 115V or 230V with (2) 3/4" Barbs outside diameter. Non-OEM replacement for all models of Watkins® Silentflo® circulation pumps used in Hot Spring, Tiger River & Limelight spas from 1986 to 2012. The...

This part is a Pump Motor only that is 48 frame 115V 2 speed with 11.0 Amps on High Speed and 2.9A on Low Speed.. You can find wet ends for this motor by clicking here.. Complete Wet Ends Motor Type Spa Motor Amperage 11.0A/2...